- Yellow Birch fresh off of the sawmill
- This is what it should look like finished
- Stickering
- Planing the first pieces after drying
- Routing sides down to proper size
- Bending the sides
- Bending the sides
- Gluing the book matched top
- Top
- Bent sides
- Besnt sides in mold
- Gluing kerfed lining
- Glued up back
- Gluing back reinforcement
- Prepping back braces
- Glueing back braces
- Gluing neck blank
- Cutting top for the rosette
- Installing the walnut rosette
- Laying out top bracing
- Gluing top bracing
- Shaping back braces
- Gluing scarf joint on neck
- Gluing braces
- Rosette
- Shaping top braces
- Gluing on back
- Gluing on top
- Soundbox assembled
- Soundbox assembled
- Cleanign up edges
- Installing end graft
- Gluing on headplate
- Working on binding
- Binding
- Binding the back
- Binding
- Progress so far
- Making a new template for shaping the neck heel
- Prepping for carbon fiber reinforcement install
- Shaping the neck
- shaping the neck
- shaping the neck
- Radius sanding the fretboard
- Neck with truss rod
- Shaping the bridge
- Gluing on the fretboard
- Assembled neck
- Headstock inlay
- Fret board inlay
- final neck shaping
- First coats of finish
- First coats of finish